
Total Care Club Memberships – Save 15% OFF all Repairs
Plumbing
$299
Plumbing
w/ 3rd Year Free. Total Savings $398.
Plumbing
w/ 4th and 5th Year Free. Total Savings $796
Total Care Club
AC/Heating (Heat Pump)
- Check condenser coil
- Check evaporator coil
- Check blower motor
- Check thermostat for proper operation
- Check and labeling of emergency shutoffs
- Check controls and safety devices
- Check condensate drain
- Check relays and contactors for proper operation
- Check ductwork for leaks
- Start and test operation and cycle of unit
- Check air flow
- Check humidifier/ dehumidifier
- Check & tighten all electrcial connections
- Check temperature and pressures
- Check capacitors
- Check proper amperage & voltage of A/C system
By keeping your central A/C system in top working
order with annual maintenance, you can cut your
monthly energy costs by about 25% and reduce
breakdowns by as much as 95%!
Electrical
- Check all wiring in main panel for proper sizing
- Check breakers for proper operation
- Check outside meter and enclosure
- Check outside main feeders
- Check surge protectors
- Tune up main panel
- Check all aluminum wiring in service panel for oxidation and
apply deoxidation compound as needed - Check ground fault protection for proper operation
- Check attic fans for proper operation
- Check exhaust fans for proper operation
- Check all accessible lights, switches, dimmers, receptacles,
ceiling fans - Check all connections to major appliances where accessable
- Check all main service grounding and tighten as needed
- Check any exposed wiring in attic, basement and garages
- Check any outside and inside disconnects
- Check grounding and connections
Electrical fires cause approximately $1.6 billion
in property damage each year. Old wiring, overloaded
circuits, and worn outlets are the main
culprits that can cause electrical
shocks and fires.
Plumbing and Drain Cleaning
- Gas or Electric
- Shut Off Valve
- Safety Valve
- Wiring
- Gas Shut Off
- Thermostats on 120F
- Flue Piping
- Check water pressure
- Test drinking water
- Check washing machine hoses
- Check all faucets for leaks to ensure proper operation
- Dye test toilets to check for leaks to ensure proper
operation - Check all drains for proper flow
- Provide Bio-Clean treatment to all drains and toilets
- Check garbage disposals for proper operation
- Check all emergency shutoff valves for proper operation
- Label all shut-offs at locations
- Check all under sink traps and shut-offs
- Check main water meter
- Check all outside spigots
Did you know that one leaking toilet and a
dripping faucet can waste over 50,370 gallons
of water a year?
Heating (Furnace)
- Check all the burners for proper operation
- Check thermocouple for proper operation
- Check the heat exchanger surface
- Check the flue pipe
- Check the inducer and blower motors
- Check the safety switch and controls
- Check the pilot assembly
- Check thermostat for proper operation
- Check drain lines and traps for proper function
- Test and label of emergency shutoffs
- Check gas valve
- Check zone valves
- Check expansion tank
- Check aquastat, relay and water regulator
- Check air flow across indoor coil and blower wheels
- Check ductwork for leaks
- Start and test operation and cycle of unit
- Check air flow
- Check humidifier/dehumidifier
- Check and tighten all electrical connections
- Check temperature and pressures
Annual checkups can prevent over 70% of all
furnace repairs as well as improve your system’s
efficiency by up to 16% — saving you money!